[JasQ]

Pobaw się zmień parametr int nPalas=2; na 1 bo to jest do pomiaru śmigieł 2 łopatowych w modelu .

Kod:

//
// This example shows one way of creating an optoswitch
// using an IR LED as emiter and an IR LED receiver as
// light sensor.
// On this case it acts as a tachometer to count the
// revolutions per second of an aeromodelism plane's
// propeller.
//
//           + GROUND                                 +GROUND          
//           |                                        |  
//           <                                        <
//           > 220 ohm resistor                       > 220 omh resistor
//           <                                        <      
//           |                                        |  
//           |                                        |
//         -----                                    -----
//          / \    >>IR LED emiter >>>>>>>>>>>>>>>>  / \   IR LED receiver
//         -----                                    -----
//           |                                        |
//           |                                        |
//           + +5VCD                                  +  ANALOG INPUT 0
//


int val;
long last=0;
int stat=LOW;
int stat2;
int contar=0;

int sens=75;  // this value indicates the limit reading between dark and light,
              // it has to be tested as it may change acording on the
              // distance the leds are placed.
int nPalas=2; // the number of blades of the propeller

int milisegundos=500; // the time it takes each reading
void setup()
{
  Serial.begin(9600);
  pinMode(13,OUTPUT);
}

void loop()
{
  val=analogRead(0);
  if(val<sens)
    stat=LOW;
   else
    stat=HIGH;
   digitalWrite(13,stat); //as iR light is invisible for us, the led on pin 13
                          //indicate the state of the circuit.

   if(stat2!=stat){  //counts when the state change, thats from (dark to light) or
                     //from (light to dark), remmember that IR light is invisible for us.
     contar++;
     stat2=stat;
   }
   if(millis()-last>=milisegundos){
     double rps=((double)contar/nPalas)/2.0*1000.0/milisegundos;
     double rpm=((double)contar/nPalas)/2.0*60000.0/(milisegundos);
     Serial.print((contar/2.0));Serial.print("    RPS  ");Serial.print(rps);
     Serial.print("   RPM  ");Serial.print(rpm);Serial.print("  VAL ");Serial.println(val);
     contar=0;
     last=millis();
   }
}